Table plate - table corner 85mm double hole per 4 pieces with stud+nut

Table plate - table corner 85mm double hole per 4 pieces with stud and nut. A table plate/table corner with an overall height of 85mm and a width of about 120mm. The angle plate has two holes and is secured with two studs and nuts (included). The table plate is attached to the base with screws (not included) and hooked into two slots in the base with the raised edge. This table plate is used to securely attach the table legs to the base of the leaf and also be able to detach them. The table legs are pulled tight against the sub-rail of the table top by the stop ends in the legs by tightening the nuts.

Dimensions of table plate - table corner 85mm double hole

This table corner has an overall height of 85mm and a width of about 120mm. The diameter of the hole is about 10.4mm and the screw holes are about 5mm.  Fasteners for securing the table leg (two nuts and studs per plate) are included. The table plates are supplied without screws as the length depends on the thickness of the bottom rail.