Mirror pivot support BRA-KON for dressing table and standing mirrors steel brass plated per 2 pcs zs

Mirror pivot support BRA-KON for dressing table and standing mirrors steel brass plated per 2 pieces. A mirror hanger for mounting a mirror between two uprights. The connector is made of steel and has a matte brass finish. This mounting bracket can rotate with resistance allowing the to tilt in two directions. This allows the mirror to be rotated into the correct position. The parts cannot be turned by hand and therefore also provide good resistance so that the mirror does not rotate back vertically by itself. The mirror is also removable because the two parts fall conically into each other. In addition, these supports can also be used to hang something else after which it is relatively easy to remove it by lifting it up.

These BRA-KON parts have long been used on dressing tables and standing mirrors and are made in England. Traditionally, two supports are used on either side of a wood-framed mirror. It is then mounted between two wooden uprights on a classic dressing table or on a stand that is on the floor.

Dimensions of the mirror pivot support BRA-KON for dressing table and standing mirrors steel brass-plated

The mounting plate of the part with the pivot point has a width of 16.5mm and a height of 43mm. The depth of this part is 10mm. The loose tapered part is 21,5mm wide and 40mm high. The total thickness is a total of 11.5mm. The connector is supplied in two sets of one rotating part and one tapered part and is supplied without screws.